Overview
11
1
1.7 Connecting the Camera
Follow the instructions below to complete IP Speed Dome Camera connection.
1.7.1 Connecting the Power
Refer to the illustrations below to connect power core through the power adaptor. The colors
of the wires vary for different power adaptors.
NOTE:
If you have purchased GeoVision’s optional power adaptors, connect
the green or green/yellow wire to GND. The two remaining wires are
interchangeable, and both wires can be connected to AC_2 or AC_1.
1.7.2 Connecting
the Ethernet Cable
Use of Category 5 Ethernet cable is recommended for network connection; to have best
transmission quality, cable length shall not exceed 100 meters. Connect one end of the
Ethernet cable to the RJ-45 connector of the IP Speed Dome Camera, and the other end of
the cable to the network switch or PC.
NOTE:
In some cases, you may need use an Ethernet crossover cable when
connecting the IP Speed Dome Camera directly to the PC.
Check the status of the link indicator and activity indicator LEDs; if the LEDs are unlit, check
LAN connection.
Green Link Light indicates good network connection.
Orange Activity Light flashes for network activity indication.
Pin
Definition
1
AC_2
2
GND
3
AC_1