Administrator
53
4
4.2.2.3 IP Filter
The IP Filter setting can be found under this path:
System> Security> IP Filter
.
Using the IP filter, access to the IP Camera can be restricted by denying/allowing specific IP
addresses.
Figure 4-5
•
Enable IP Filter
Check the box to enable the IP Filter function. Once enabled, the listed IP addresses
(IPv4) will be allowed/ denied access to the IP Camera.
Select <Allow> or <Deny> from the drop-down list and click on the <Apply> button to
determine the IP Filter behavior.
•
Add/ Delete IP Address
Input the IP address and click on the <Add> button to add a new filtered address.
The Filtered IP Addresses list box shows the currently configured IP addresses. Up to
256 IP address entries may be specified.
To remove an IP address from the list, select the IP and then click the <Delete> button.