page | 19
Getting Started
Installation
3.
Connect a single strand of SC-terminated 50μ OM3e multimode fiber optic cable from
each SC-type connector on the Sender card to each Receiver unit, as shown below.
4. Connect a DVI cable from the DVI Out port on each 1FO Receiver unit to a DVI
display.
5.
Connect the included power supplies to each 1FO Sender and Receiver unit, then
connect each power supply to an available electrical outlet. The Link indicator will
glow bright green to indicate a solid connection between the matrix and the Receiver
unit. The Power indicator will glow bright blue to indicate that the Sender and
Receiver units are being powered.
Connect both AC power cords from the
8x8 Modular Matrix
to available electrical
outlets. Connecting both AC power cords will provide redundancy should one of
the power supplies fail. It is recommended to connect each power cord to electrical
outlets on two separate circuits.
If the Link LED indicators are OFF, inspect the fiber cable for loose connections or
possible defects.
GEF-DVI-1FO-R
GEF-DVI-8FO-S
DVI cable
DVI display
GEF-DVI-1FO-R
Multimode Fiber Optic cable.
Up to 6600 feet (2 kilometers)
