page | 120
Appendix
Card Removal and Installation
Although each
8x8 Modular Matrix
is sold pre-configured, both input and output cards
can be removed or added to fit the needs of the application. Each module can easily be
removed and installed without using any special tools.
1. Power-off the matrix.
2. Turn the matrix around so that you are facing the back of the unit.
3.
Loosen the fastening screws on both sides of the card (or cover plate) to be removed.
Each card / cover plate has two fastening screws.
WARNING:
Modules are sensitive to Electrostatic Discharge (ESD)
which can damage the module. Avoid touching the module contacts
or the components on the module. Always hold modules by the
edges or by the knobs on the front of the module. Never slide a
module over any surface. When installing/replacing modules, do not
install an input module in to an output slot or an output module to an
input slot. This will damage the matrix and void the warranty.
STOP:
Before installing modules and prevent the risk of possible
electrical shock, unplug the AC power cord from back of the matrix.
Pull knob
Fastening screw
