GE N60 UR Series, Инструкция по эксплуатации

Страница: 332 / 500

7-2 N60 Network Stability and Synchrophasor Measurement System GE Multilin
7.1 COMMANDS 7 COMMANDS AND TARGETS
7
This menu contains commands for clearing historical data such as the event records. Data is cleared by changing a com-
mand setting to “Yes” and pressing the ENTER key. After clearing data, the command setting automatically reverts to “No”.
7.1.4 SET DATE AND TIME
PATH: COMMANDS
ÖØ
SET DATE AND TIME
The date and time can be entered here via the faceplate keypad only if the IRIG-B or SNTP signal is not in use. The time
setting is based on the 24-hour clock. The complete date, as a minimum, must be entered to allow execution of this com-
mand. The new time will take effect at the moment the ENTER key is clicked.
CLEAR DEMAND
RECORDS?: No
Range: No, Yes
CLEAR ENERGY?
No
Range: No, Yes
CLEAR UNAUTHORIZED
ACCESS? No
Range: No, Yes
CLEAR DIRECT I/O
COUNTERS? No
Range: No, Yes. Valid only for units with Direct Input/
Output module.
CLEAR PMU 1 RECORDS?
No
Range: No, Yes
CLEAR PMU 2 RECORDS?
No
Range: No, Yes
CLEAR PMU 3 RECORDS?
No
Range: No, Yes
CLEAR PMU 4 RECORDS?
No
Range: No, Yes
CLEAR PMU 1 CONFIG
CHANGE COUNTER? No
Range: No, Yes
CLEAR PMU 2 CONFIG
CHANGE COUNTER? No
Range: No, Yes
CLEAR PMU 3 CONFIG
CHANGE COUNTER? No
Range: No, Yes
CLEAR PMU 4 CONFIG
CHANGE COUNTER? No
Range: No, Yes
CLEAR TELEPROTECT
COUNTERS? No
Range: No, Yes
CLEAR ALL RELAY
RECORDS? No
Range: No, Yes
„„
COMMANDS
„„
SET DATE AND TIME
SET DATE AND TIME:
2000/01/14 13:47:03
(YYYY/MM/DD HH:MM:SS)