Chapter 4: Moving and Positioning
Definium AMX 700 X-Ray System
5161515-1EN
Rev. 6 (10 February 2008)
4-2
Operator Manual
© 2008 General Electric Company. All rights reserved.
If moving down hallways or just traveling from one room to another, first make sure that the telescoping
arm is properly positioned and securely latched and that the detector is also in the detector bin so that
maximum speed can be reached.
Then, simply grip the drive handle (Figure 4-2) and steer the unit to your destination.
Figure 4-2
Drive handle
WARNING:
Movement of the Definium AMX 700 x-ray unit could cause the horizontal arm to slide and
strike an operator or patient if not latched properly. Latch telescoping arm properly before
moving the unit.
WARNING:
Do not drive or position the Definium AMX 700 unless standing directly behind it (Figure 4-
3). Failure to do this may result in loss of control causing serious injury and equipment
damage.
Figure 4-3
Proper driving position
FOR
TRAINING
PURPOSES
ONLY!
NOTE:
Once
downloaded,
this
document
is
UNCONTROLLED,
and
therefore
may
not
be
the
latest
revision.
Always
confirm
revision
status
against
a
validated
source
(ie
CDL).
