GE CyberDome Series, Руководство по установке, Страница: 50 / 52

Appendix C: 8-inch Pendant-mount Housing Installation CyberDome Series Installation Manual
50
A06-8SG0/B/April2006/1033921C
Step 7) Remove the three hex nuts that hold the pendant housing to the mounting flange.
When installing the pendant housing with the W option, remove the triangular
stiffener plate (see
Figure 71 ).
Step 8) Guide the housing and flange assembly through the mating holes in the wall
bracket and reinstall the three hex nuts on the studs (refer to
Figure 71 ). Using a
3/8-inch nut driver or socket wrench, securely tighten the three mounting nuts on
top of the housing to a torque of 3 to 5 ft-lb.
CAUTION!
The KTA-02-12 Wall-mount Bracket is not waterproof, but allows water to drain away before it
reaches the housing lip. DO NOT seal the wall bracket—this will prevent proper drainage.
Step 9) Prepare the cables as shown in Figure 72 .
Figure 72: Preparing the Cables
Figure 71: Attaching the Housing to the Wall Bracket