GE CyberDome Series, Руководство по установке, Страница: 31 / 52

CyberDome Series Installation Manual PTZ and Dome Installation
31
A06-8SG0/B/April2006/1033921C
PTZ AND DOME INSTALLATION
RS422 Termination
Step 1) Locate the red, sliding termination switch on the PC card at the top of the hous-
ing. See
Figure 47 .
Step 2) If the RS422 control cable connected to the CyberDome does not loop out to
another unit (i.e., it is the final receiver location), place the switch in the ON
position (as shown in
Figure 47 ).
Step 3) Apply 24 VAC power to the housing. The housing’s red LED power indicator lamp
should illuminate. It is located on the underside of the PTZ bracket.
Installing the Pan/Tilt Assembly
This section gives detailed procedures for installing the CyberDome’s motorized pan/tilt
assembly. Installation involves securing the pan/tilt assembly to the upper housing and set-
ting the receiver’s DIP switch.
NOTE: The pan/tilt assembly may be installed while power is applied to the housing.
Proceed as follows:
Step 1) Insert the safety catch (A) though the channel in the retaining bracket (B)
attached to the upper housing. See
Figure 48 .
Note:
When completing the next step, the CyberDome will move (become active) momentarily in both the
pan and tilt directions, as part of its orientation protocol.
Step 2) Push the spring latch handle (C) outward, while pivoting the pan/tilt assembly up
until it is vertical. Secure the pan/tilt assembly by releasing the latch handle and
engaging the catch tab (D). See
Figure 48 .
Step 3) Check to ensure that the four mounting nuts (E) are mated with the four align-
ment holes (F). See
Figure 48 .
Figure 47: Line Termination Switch on PC Card