GE CyberDome Series, Руководство по установке, Страница: 17 / 52

CyberDome Series Installation Manual Housing Installation
17
A06-8SG0/B/April2006/1033921C
7-inch Pendant-mount Housing Installation
The 7-inch pendant housing can be mounted using one of three methods:
•
Method 1 – Suspended from the KTA-20/KTA-20T CyberMount
(page 17)
• Method 2 – Suspended from the KTA-21/KTA-21W Swing Mount
(page 21)
• Method 3 – Suspended from a 1.25 in. pipe
(page 25)
Method 1: CyberMount Installation
The KTA-20/KTA-20T CyberMount suspends the CyberDome from a vertical surface.
It can be attached directly to the vertical surface or mated with a KTA-25/KTA-25W Corner-
mount Bracket, a KTA-26/KTA-26W Pole-mount Bracket, or a KTA-27/KTA-27W Roof-mount
Bracket. It provides the path for the video, 24VAC, and RS422 data control cables. For instruc-
tions on installing the corner-, pole- or roof-mount brackets, refer to
Appendix A: Accessory
Installation .
To install the 7-inch pendant housing with the CyberMount, proceed as follows.
CAUTION!
DO NOT provide power to the housing until all installation steps are complete.
First, mount the CyberMount to a vertical surface:
Step 1) If a 1/2 in. (1.27 cm) conduit needs to enter the side of the CyberMount, com-
plete the steps in the
KTA-20/KTA-20T CyberMount (Side Conduit Entry ) section
of Appendix A: Accessory Installation .
Step 2) Loosen the two CyberMount cover screws enough to remove the cover (removing
the screws is not necessary). See
Figure 20 .
Step 3) Remove the CyberMount cover and interface module. See Figure 20 .
Step 4) Place the CyberMount against the vertical mounting surface, ensure that it is
level , and then mark the location of the four mounting holes and the center cable-
entry opening. See Figure 21 .
Figure 20. Removing the Cover and Interface
Module of the CyberMount Figure 21. Marking the Mounting Holes