Page 1 - 2
Safety
Explorer 107 Operation and Maintenance Manual
© GBC Pro - Tech December 1999
In addition, the heating components of the
Explorer 107 can reach temperatures of over 200
o
F
( 100
o
C ).
D A N G E R
At these temperatures there is a danger of
severe burn if the rolls are touched during
setup, operation or servicing.
INFORMATION
Only a qualified service technician should
perform any procedure requiring the
cabinet doors to be opened.
The word qualified is defined below;
Qualified ;
• Any engineer that has experience with electrical
and mechanical design of lamination equipment.The
engineers should be fully aware of all aspects of safety
with regards to lamination equipment.
• Any commissioning or service engineer must be
of competent nature, trained and qualified to GBC Pro-
Tech standards to fulfill that job. This person will have
completed and passed the full service training course from
GBC Pro-Tech.
• Any GBC Technician, GBC Specialist, and / or
GBC Pro-Tech Technician that has been through the GBC
Pro-Tech service training course.
An important feature of the Explorer 107
laminator are the safety latches and the interlocks. The
front safety shield and the feed table are both equipped
with safety latches. When a safety latch is not in the locked
position, the motor is disabled. Refer to Figure 1.2.1
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
W A R N I N G
Figure 1.2.1 Safety latches
R
UR
O
N
O
Safety latches
Safety latches
Under the feed table
