Page 6 - 10
Applications
© GBC Pro - Tech December1999
Explorer 107 Operation and Maintenance Manual
r) Once the last image has completely traveled
pass through the pull rollers, press
O F F
under MOTOR SPEED.
1
2
3
4
5
6
7
8
9
10
M O T O R S P E E D
O N
O F F
R E V E R S E
s) Raise the main roller and pull roller.
CAUTION
Never leave the rollers in the down position
without rolling. Prolonged contact in one
area can form flat spots on the rollers.
g) Press POWER to “ O ” if finished with the
laminator.
!
A M
A T
M d
x
u v
g
V
u u
A
P
u
u
W
u
g
U
u
g
u
k
A
M x
g
d
# # # # # # # # #
M d
q u
S
T
O
P
E
M
E
R
G
E N C Y
Power
6.2 New film to existing film
The following describes a method for loading film
whereby the existing filmpresent on the heat rollers may
be used in place of the threading card to draw the new
film through the laminator.
The adhesive from the existing film must be tacky
or activated. The leading edges of the new film will be
overlapped onto the tacky adhesive of the old film.
The existing film and the new film will be pulled
through the laminator together. Refer to Figure 6.1.1
Poly-in / Poly-out.
INFORMATION
The laminator must be heated for this
method of webbing.
W A R N I N G
The following steps are performed while
the laminator is HOT! Avoid contact
with the heating components!
