Page 6 - 9
Applications
Explorer 107 Operation and Maintenance Manual
© GBC Pro - Tech December 1999
k) Watch the leading edge of the threading card to
ensure that it enters the nip rollers and is being
pulled intothe laminator.
INFORMATION
The threading card will guide the two films
into the pull rollers.
l) Once the threading card has passed completely
through the pull rollers, press
O F F
under
MOTOR SPEED.
1
2
3
4
5
6
7
8
9
10
M O T O R S P E E D
O N
O F F
R E V E R S E
m) Check film alignment and film tention. Adjust
as neccessary.
Excessive brake tension may cause the
output to curl. Always use the minimum
brake tension required to complete the task.
INFORMATION
n) Set a desired working speed by turning the
SPEED ADJUST dial clockwise.
M O T O R S P E E D
O N
O F F
R E V E R S E
1
2
3
4
5
6
7
8
9
10
o) Set the feed guides on the feed table if desired.
p) Press
O N
under MOTOR SPPED
when ready to laminate.
1
2
3
4
5
6
7
8
9
10
M O T O R S P E E D
O N
O F F
R E V E R S E
INFORMATION
The laminator will operate only when
all safety latches are in the fully
latched position.
