NetXpress LX & CM-30R Installation & Operation Manual
4
–
Configuration & Operation
Version 1.1
4-88
GatesAir, Inc.
Intraplex Products
Alias Name:
The name you specify for the module to help identify the module type.
Shelf Name:
The name you specify for the multiplexer shelf housing the module.
Card Address:
Each module must have a unique address in the shelf. Valid addresses are 1 through
36.
TDM Bus:
The TDM bus on which the channel module resides.
Module Adapter:
The type of module adapter being used with the module.
Remote Control:
The mode of operation the module is set to use:
REMOTE
or
LOCAL
.
Enable Module:
Select this check box to place the module in service. If the check box is not selected,
the module is offline.
Module Configured:
Whether the module is properly configured.
In Service:
Whether the module is in service (green) or out of service gray).
Alarm:
If there is an active alarm (red) or alert (yellow) on the module.
Refresh:
Shows if the automatic browser refresh is enabled for 1 minute (
M
), 5 seconds (
5s
), 10
seconds (
10s
), or 30 seconds (
30s
). Click a rate to change how frequently the browser refreshes this
page.
TDM Bus Configuration
TDM Bus:
The current bus side, either
Bus
A
or
Bus
B
.
Timeslot:
The current setting for the starting time slot on the module.
Other Configuration
Local Loopback:
If this check box is selected, local loopback is enabled.
Use Signaling:
If this check box is selected, E-lead and M-lead circuit signaling is enabled.
Set C Bit to 1:
If this check box is selected, the C bit is set to 1 (forced on).
Channel 1-4
Active:
The channel activity (Green = channel is active or off-hook; gray = channel is idle or on-
hook).
M-Lead Busy:
The M Lead activity (Green = M lead is active or unknown; gray = M lead is inactive or
not enabled.
E-Lead Busy:
The E Lead activity (Green = E signaling lead is active or unknown; gray = E signaling
lead is inactive or not enabled).
Loopback:
The channel is in local loop back mode (green), or there is no active loopback (gray).
Previous Card:
Click this button to view configuration and status pages for the module on the
immediate left of this module.
Next Card:
Click this button to view configuration and status pages for the module on the immediate
right of this module.
