4
–
Configuration & Operation
NetXpress LX & CM-30R Installation & Operation Manual
Version 1.1
GatesAir, Inc.
4-3
Intraplex Products
●
Networking
●
Routing
●
IP Access List
●
T1/E1 System Mode Selection
●
Stream Creation
–
TDM to IP
●
System Timing Configuration
●
SNMP Community
●
Configuration Backup/Restore
4.2.3.1 Networking
You need to change each network interface from its default IP address to the target IP address that is
appropriate for your network. The defaults IP address assigned to the network interfaces are
●
192.168.2.1 for the WAN interface
–
You need to change the default WAN interface IP address
to permit inter-networking of multiple NetXpress LX chassis. The WAN interface requires a static IP
address. Dynamic addressing of the WAN interface (DHCP) is not supported.
●
192.168.1.1 for the LAN interface
–
You need to change the default LAN interface to permit
inter-networking of multiple NetXpress LX chassis. DHCP is supported on the LAN interface.
Changes to network interfaces are made using the
Network Interface Configuration
page (Section
4.3.4
–
Configure the Network
).
4.2.3.2 Routing
Routing is necessary when the path to the
destination IP address is not apparent
or not within the
same
local subnet as the originator
. To add routing information to the NetXpress LX system, perform
these steps:
1.
Point to
Networking
and click
Forwarding
(Figure 4-2).
Figure 4-2. Networking | Forwarding Table
2.
Click
on the
Forwarding
Table
header (Figure 4-3).