4
–
Configuration & Operation
NetXpress LX & CM-30R Installation & Operation Manual
Version 1.1
GatesAir, Inc.
4-9
Intraplex Products
f.
Click
Next
to advance to
Stage 4
(Figure 4-12).
Figure 4-12. Stream Creation
–
Stage 4 (TDM to IP)
6.
On the
Stage 4
:
TDM Bus Parameters
page, perform these steps:
a.
Either accept the
TDM Bus
default (
TDM Bus 1A
) or click
TDM Bus 1B
.
b.
Click appropriate number slots to set the
Frameloss Mask
(a number slot becomes yellow
when selected).
c.
Type the
TDM Bus Starting Channel
(default is
1
).
d.
Type the
TDM Bus Channel Range
(default is
1
).
e.
Type the
TDM Bus Frames Per Packet
(default is
200
).
f.
For
Jitter Buffer Size
packets other than
32
, click a number (
8
,
16
,
64
, or
128
; default is
32
).
g.
Click the
Stream Program Type
if different from
Compressed Audio
/
Data
(
Enter
Underrun Value Manually
or
Linear Audio
/
Voice
; default is
Compressed Audio
/
Data
).
h.
If you selected
Enter Underrun Value Manually
, type a number for
Packet Underrun
Byte
. (If you selected
Linear Audio/Voice
or accepted the default,
Packet Underrun Byte
is unavailable; you cannot type in this field.)
Note:
You cannot directly change the values for
Stream Bandwidth
,
Stream Delay
, or
Packet Size
; these reported values depend on your selection
Channel Range
and
the number of
TDM Bus Frames per Packet
.
i.
Click
Next
to advance to the
Summary
page (Figure 4-13).