Full Spectrum Laser MUSE TITAM, Руководство по эксплуатации

Страница: 75 / 87

If replacing the tube, unplug the machine and let rest for one hour for
capacitors to discharge to avoid electrocution.
Handle CO2 tube with care, glass is fragile and can cause
lacerations if mishandled.
Installing the CO2 Laser Tube
CO2 Laser Tube Replacement
1. Power Off Machine: Power off and unplug your unit. Wait at least 1 hour for capacitors to discharge.
2. Disconnect Water: Detach the water tubes from their connectors on the laser tube and drain the
water into a bucket.
3. Remove Water Tubes (Step One): Remove the two (2) water tubes from the bulkheads on the back
of the machine and carefully drain any water into a bucket. Use the small piece of tubing that shipped
with your laser to shunt the two water bulkheads in the back of the machine together.
4. Remove Water Tubes (Step Two): Gently remove the water tubes from the laser glass bulkhead. Be
careful not to let any excess water in the tubes spill onto the machine’s components.
5. Remove Metal Gantry Strap: Using a 2.5mm hex wrench (included with your purchase),remove the
Two (2) M4 bolts From the metal strap that wraps around the tube.
6. Fold Down Gantry Tube Strap: Carefully push the metal gantry strap panel downwards to gain
access to the tube. * Note * - This panel is made to bend so don't be afraid to bend it out of the way;
But do not bend too much as the hinge will fail if continued to be folded open multiple times.
7. Remove Universal Laser Pin Connector: Carefully unscrew the universal laser pin connector off the
aperture end of the laser tube. Next unclip the connector on the other side of the laser tube.
8. Remove The Four Gantry Mounts: The last step in your laser tube removal will be the four bolts
located on the front side of your gantry behind the belts. .
9. Tube Disposal: The old tube can simply be disposed of via a trash can. It is important to know
nothing about the old tube is dangerous itself besides the glass.
10. Simply reverse these steps to install your new laser tube.
Now that you have switched the old laser tube for the new laser tube.
You will need to retest the mirror alignment and possibly go through the
mirror alignment procedure again.
74