Full Spectrum Laser MUSE TITAM, Руководство по эксплуатации

Страница: 24 / 87

Do not over-tighten or over-loosen adjustment screws. Tightening
or loosening any of the three adjustment screws on the mirrors or the
red dot diode will move the position in a particular direction depending
on the positioning of the other screws. Some experimenting is required
to understand the relationship of each screw and how adjusting one
affects the red dot’s positioning. When adjusting the screws, use the
absolute minimum turn of the hex wrench to move the red dot or the
mirror into position.
Stage 1: Prep
Prepare your tools and workspace.
23
Before starting any project, be sure you are aware of all safety
issues. Be sure you read and understand all safety warnings
presented in Section I.
1. Power on Laser Cutter: Turn on the machine by hitting the power switch. Allow the machine time to boot
up the touch screen operating system.
2. Unlock Driver Motor: On the touch screen, press the “Locked” icon to switch to “Unlocked” position. The
button will now display the “Unlocked” icon.
3. Gather Tools: A 2.5mm hex wrench and a supply of thermal paper are required to perform the mirror
alignment procedure (if required).