Fukuda VaSera VS-2000 Series, Руководство по эксплуатации

Страница: 68 / 234

2-18
Chapter 2 Installation
3
Touch [Communication].
4
Select [ON] for [Communication] in the
[General] tab.
Check that [Method] is set to [Wired LAN].
5
Set the IP address of the device.
1)
Touch [DMS Settings].
2)
Touch the [Examination Equipment Info] tab.
3)
Touch "Examination Equipment Name" and
enter the examination equipment name.
• The examination equipment name is entered in the
same way as the patient name in "Chapter
4
Entering Patient Information"(P4-1).
• The default setting for the examination equipment
name is "VASERA". An examination equipment
name does not need to be entered if using this
name.
4)
Touch [IP address].
5)
Enter the IP address.
Refer to "
■
Example Setting: For "Example of
Network Configuration" (P2-16)" (P2-19) for
details on the settings.
6)
Touch [ ].
7)
Touch the [DMS Settings] tab.
8)
Enter the subnet mask and default gateway
in <Gateway>.
Refer to "
■
Example Setting: For "Example of
Network Configuration" (P2-16)" (P2-19) for
details on the settings.
6
Register the host.
1)
Touch the [Host Info] tab.
2)
Enter the host name, IP address and port
number in <Host Info X>.
"Host" refers to information about the computer to
connect. Set the host name, IP address and port
number. Up to 6 hosts can be registered.
Refer to "
■
Example Setting: For "Example of
Network Configuration" (P2-16)" (P2-19) for details
on the settings.
7
Select the host to be used.s
1)
Touch [DMS Settings].
2)
Touch the host to be used
([Recording&Playback Host], [PW/BP Host],
[Patient Info Host]).
3)
Enter the host number set in step 6 (the "X"
part of "Host Info X", 1-6).
• VSS can be used as pulse wave hosts or patient
information hosts.
4)
Touch [Enter].
8
Configure the network printer settings.
Network printers that can print without a computer (laser
printers) can be connected.
1)
Touch [Printer].