PART Ⅲ INSPECTION AND SERVICE TROUBLE SHOOTING
1．FUSE
●
Circuit which is related to each fuse and fuse capacity are shown below.
●
When abnormality occurs in wiring circuit, relevant fuse cuts.
●
When fuse blows, stop using the machine and ask your dealer for
inspection and service.
SH1-17
2．TROUBLE SHOOTING
Refer to "Engine manual" for ☆
TROUBLE SHOOTING
PROBLEM
CAUSE
SERVICE
Type and capacity of fuse
Circuit
Electrical cylinder
Blade fuse 20A
Engine
Chute
Light
"Easy" button
Ai back auto lift
Snowmatic plus
Blade fuse 30A
Clean fuel filter.
→☆
Ignition plug is dirty or the gap between
electrodes is not adequate.
Clean ignition plug. And adjust the gap of electrodes.
→☆
Recharge or exchange battery. Or connect and fix
terminals securely. →P.55, 56
Wire is disconnected.
Fuse is cut.
Contact your dealer.
The engine is not
powerful.
The machine is doing unreasonable snow
removal work.
Decrease travel speed for work and raise auger
housing to decrease load to the engine. →P.38
to 40
Amount of engine oil is insufficient.
Replenish oil to the prescribed amount.
→P.26, 52
The engine does not
start.
Starting procedure is incorrect.
There is no fuel in the machine.
Refuel the machine.
→P.26
Fuel filter is clogged.
Follow correct procedures for starting.
→P.30
The machine does
not travel although
travel clutch lever
is set at "On".
Change lever is at "N.Neutral".
Travel belt is loosened.
Contact your dealer.
Amount of HST oil is insufficient.
Set the lever at " " or " ", and then, move it
to "Forward" or "Backward".
→P.21, 32
Battery discharged or battery terminal is not
connected well.
Unsuitable fuel is used.
Use proper fuel.
→☆・P.26
Fuse
IMPORTANT
- 58 -
