PART Ⅱ OPERATION HOW TO REMOVE SNOW
■WHEN IT IS WINDY
●
If snow is thrown against the wind direction, it
cannot go
to the right place which operator intended.
If thrown snow goes toward operator, it may cause
trouble to operation. Throw snow to the same
direction as the wind direction as much as possible.
Avoid snow removal work when wind is strong.
●
Pay attention to the wind direction, wind flow, and
work environment to prevent emission from
accumulating around operator.
02-8619-36
■ADJUSTMENT OF BLADE AND SLEIGH
●
The blade scrapes snow which is left on the
ground to finish snow removing and prevents
auger from contacting with the ground. The
sleigh prevents the blade from cutting into the
ground.
●
When shipping the machine, the blade is set 3 to
5mm lower than auger. The sleigh is set 3 to
5mm lower than blade.
SH2-15
●
Set sleigh lower for rugged ground such as
gravel road. Set blade as high as auger for frozen,
hard surface so that augers break frozen snow.
In this case, set sleigh slightly lower than auger.
SH2-16
●
Adjustment of sleigh
●
Stop the engine. Make sure every
part has stopped its operation
completely before carrying out
adjustment.
●
Do not enter under the machine.
(1)
Raise auger housing.
(2)
Stop the engine and make sure every part
has stopped its operation completely.
SH2-18
(3)
Loosen the fixing bolts.
(4)
Adjust the height of sleigh according to work conditions and fix it with the fixing bolts
securely.
●
Set right sleigh and left sleigh at a same height.
３
～５
mm
Auger
Blade
Sleigh
Freeze
Auger
Blade
Sleigh
３
～５
mm
Sleigh
Fixing bolt
IMPORTANT
WARNING
DANGER
- 39 -
