PART Ⅱ OPERATION HOW TO REMOVE SNOW
(1)
Set change lever at "N.Neutral".
(2)
Refer to "Start the engine" (p.30) and start the engine.
●
When starting engine indoors, open the windows for sufficient ventilation.
If the place is poorly ventilated, poisoning may occur due to exhaust gas,
which is very dangerous.
●
Set travel clutch lever at "Off" and change lever at "N.Neutral" before
starting the engine.
●
Check if covers are attached correctly before starting the engine.
●
When starting the engine, give a signal aloud to surrounding people.
(3)
After warming up, adjust engine revolution by throttle lever.
(4)
Operate chute control lever and decide on
snow throwing direction and distance.
SH2-04
(5)
Operate auger housing control lever and
decide on height and angle of auger housing.
●
If auger housing control lever
is operated continuously,
protection device is activated
by heat of hydraulic cylinder
and auger housing cannot be
operated. In that case, stop
using the machine. Resume snow
removal work when hydraulic
SH2-03
cylinder has cooled down.
●
Control auger housing during
work according to quality and
amount of snow and condition
of the surface of road.
(6)
Move change lever from "N.Neutral" to
"Neutral point" of " " side.
SH2-13
Neutral point
Auger housing
control lever
Left tilt
Right tilt
UP
DOWN
Chute control
lever
SUPPLEMENT
WARNING
WARNING
CAUTION
CAUTION
CAUTION
Neutral
Travel
Work
Up
DOWN
UP
Down
Left
Right
Left
Right
Up
Down
Left tilt
Right
- 36 -
