Format kappa 30, Руководство пользователя

Страница: 74 / 96

Panel Saw
Kappa 30 / kappa 40
Operation
9.7.11 Groove cuts
Fig. 105: Groove cuts
Fig. 106: Groove cuts
Warning! Risk of injury!
• Groove cuts may only be carried out with an over-
head saw guard! Do not use a saw guard!
• Do not pull back the rip fence‘s guide!
• Do not remove the splitter!
• If the saw blade protrudes over the upper edge of the
rip fence guide, it is not safe to guide the workpiece.
1.
Take note of general procedures for authorized wor-
king techniques.
2.
Adjust the rip fence to the desired position.
3.
Lock the sliding table into a centre position.
4.
Set the cutting height to a maximum of half of that of
the workpiece’s thickness.
5.
Select the cut sequence so that the cut batten falls
onto the sliding table side.
Should the cut batten fall to the right side of the circu-
lar saw, a wooden push stick has to be used due to
the high kickback risk.
X
Workpiece thickness
X/2
Cutting height
A higher auxiliary fence must be used to ensure that
the workpiece is guided safely.
• When working on small workpieces, use a wooden
push stick, a push stick or a load feeding accessory.
74
X/2
X