Format kappa 30, Руководство пользователя

Страница: 71 / 96

Panel Saw
Kappa 30 / kappa 40
Operation
Warning: Risk of injury: Trimming may only take place if using an trimming shoe!
Fig. 98: Trimming with trimming equipment
Using trimming equipment:
1. Take note of general procedures for authorised
working techniques.
2. Mount the trimming equipment (Assembly instructions
„Trimming equipment“).
3. Lock the sliding table.
*)
4. Clamp the unfinished plank, with the hollow side
facing upwards into the edging equipment.
5. Switch on the circular saw.
6. Feed the trimming equipment and the work-piece
together constantly past the saw blade, keeping
fingers pointed towards the palm of the hand.
*)
*)
The trimming equipment is pushed along the sliding table‘s groove.
9.7.5 Longitudinal cut
Fig. 99: Longitudinal cut
9.7.6 Cutting battens
Fig. 100: Cutting battens
1. Take note of general procedures for authorised work-
ing techniques.
2. Adjust the parallel cutting fence to the desired meas-
urement.
3. Lock the sliding table into a center position.
4. Place the workpiece against the parallel cutting
fence.
5. Switch on the circular saw.
6. Feed the work-piece constantly past the circular saw,
keeping your fingers balled into a fist.
1. Take note of general procedures for authorised work-
ing techniques.
2. Modify the guide of the rip fence to a narrow guide
edge.
3. Set the parallel cutting fence to the desired measure-
ment.
4. Lock the sliding table into a center position.
5. Place the workpiece against the parallel cutting
fence.
6. Kreissäge einschalten.
7. Feed the work-piece constantly past the circular saw,
keeping your fingers balled into a fist.
71