FOR-A HVS-12ROUA, Инструкция по установке и эксплуатации

Страница: 38 / 250

24
4-3-2. Changing Parameter Values
The menu page is divided into two rows above and below and six horizontal blocks. Up to six
parameters can be displayed in one row. To change a parameter, turn the control F1 to F6
that is directly below the block. Parameters can be changed for the row that is selected
(cursor bar is displayed).
Function control operations (F1 to F6) Description
Turn clockwise Increases value.
Turn counter-clockwise Decreases value.
Press
Switches to keypad input.
Confirms the input value.
Press and hold down at least 1 sec. Reset the parameter to default value.
Turn while pressing
Moves to next/previous page in the pop up
menu or quickly increases/decreases value.
IMPORTANT
In the system setup parameters in the MU SETUP and OU SETUP menus, after the
parameter value is changed, it needs to be confirmed by pressing ENTER on the
keypad or pressing the control under the parameter. In this case, after the settings are
changed, the setting value is highlighted, and ENTER and CLEAR in the keypad light
up. Pressing ENTER or the control confirms the value. Pressing CLEAR cancels the
value.

Example of changing parameter (for M/E2-KEY1 menu)
In this example, we will change the transition rate in the KEY1(1/6) menu. If the cursor bar is
in the top row, press the DOWN button to move it to the row below.
Turning the F4 control button changes the value of RATE (Transition Rate) for KEY1. Turning
control buttons F1 and F2 enables adjustment of the KEY1 clip and gain.
To make the MASK and other settings, press the DOWN button to move to the next menu
when up or down movement is possible, the UP or DOWN button is lit.
Control buttons for changing the setting values:
Used for changing parameter shown above button
SYSTEM / TRANSITION
SYS
MU
SETUP
OU
SETUP
FUNC
FILE
M/E
M/E2
M/E1
TRANS
BKGD
KEY1
TRANS
BKGD
KEY1
COPY
COPY
WIPE
PATT
KEY2
WIPE
PATT
KEY2
SWAP
PASTE
KEY3
KEY3
BLOCK
WIPE/DVE
MODIFY
WIPE/DVE
MODIFY
F1 F2 F3 F4 F5 F6
KEY1(1/6) SOURCE/INSERT
KEY
TYPE
BUS
GAIN
1.0
TYPE
BUS
KEY SIGNAL
CLIP
50
SIGNAL
IN01
TRANSP
0.0
SIGNAL
IN01
RATE
30
INVERT
OFF
TRANSITION
LIMIT
OFF
FAM
OFF
LEVEL
100.0
INSERT SOURCE
Cursor bar
Cursor bar
Moves to previous / next page.
Moves to page above / below.
Goes back/forward in
the navigation history.