47
Confir
mi
ng before
Use
Pow
er ON/OFF
1
Press and hold
for at least one second.
After the Wake-up display (see page 138) is displayed, the Stand-by display appears.
p
If you have stored many Phonebook entries or mail messages, it may take a while for the display to
appear.
p
If the clock is set, the current date and time are shown. When Set Time is set to “Automatic”, the time is
automatically corrected.
p
When “
” is displayed, the FOMA phone is out of the service area or in the place where the radio
waves do not reach. Move to a location where “
” disappears.
p
If the UIM is not attached or there is something wrong with it, a warning
message will come up.
1
Press and hold
for at least two seconds.
The exit display appears and the power goes off.
p
You cannot turn on the power immediately after turning off the power. Wait a few seconds.
■
When the battery is running out
The display on the right appears and the empty battery alarm sounds for about 10 seconds. To stop this alarm,
press any key other than
and
. About one minute later, the FOMA phone will be turned off.
p
During a call, a beeping tone from the earpiece notify you of the empty battery. About 20 seconds later your
call will be cut and then one minute later the FOMA phone will be turned off.
p
The battery tone from the speaker does not sound while “Manner mode” or “Super silent” is activated, or “LVA
tone” is set to “OFF” in “Original”.
Power ON/OFF
Turning Power On/Off
Turning Power On
<Recharge Battery
display>
<
>
<Stand-by display>
When the UIM is
malfunctioning
When the UIM is not
attached or damaged
■
When “PIN1 code entry set” of “PIN setting” is set to “ON”
Enter the four- to eight-digit PIN1 code after you turn on the power. When the correct PIN1 code is entered, the Stand-by display appears.
See page 154 for PIN1 code.
■
When “Auto reset setting” of “Notice call cost” is set to “ON”
Enter the four- to eight-digit PIN2 code after you turn on the power. When the correct PIN2 code is entered, the Stand-by display appears.
If you press
or
without entering the correct PIN2 code, “Auto reset setting” is set to “OFF” and the Stand-by display
appears.
See page 154 for PIN2 code.
■
When you have not operated FOMA phone for a certain period
If you have not operated the FOMA phone for a certain period with the power turned on, the indication on the display and Private window
goes off and the circumferential part of the Command Navigation key flickers at about five-second interval when the FOMA phone is open.
The display comes on again when you perform any operation.
p
You can set the display to remain on, for even when the FOMA phone has not been operated for a certain period, by setting “Power
saver mode” of “Display setting” to “OFF”.
Turning Power Off
Содержание P702i
