FMS BKS309.W.M, Руководство по эксплуатации

Страница: 23 / 48

Operating Manual BKS309.W.M
22.02.2019 23
8 Operating parameters
Adjusting the offset [Ref Pos]
Description: the is stored as long the controller is connected to the power supply.
Range: -5.00 to +5.00 Default: 0.00
Increment 0.01 unit: [mm]
Origin of the reference value [Ref Mode]
Description: This parameter allows you to define the origin of the reference value
when you switch to the automatic mode.
Setting: [Manual]
Description: This setting will take the reference value from the parameter [Ref
Mode] (default).
Setting: Automatic [Auto]
Description: this setting will take the current position of the web (in the sensor
area) as reference value.
Note: The two parameters [RefMode] and [SafeRef] are conditionally
dependent on each other. If you require one of both functions, either
set [RefMode] to [Auto] or [SafeRef] to [Yes] .
Do not activate both functions simultaneously!
Storing changes of the reference value [SafeRef]
Description: This parameter stores changes of the reference value and restores
them after a restart of the system or sets it to zero.
Setting: [No]
Description: Sets the reference value to zero after a restart of the system.
(Default)
Setting: [Yes]
Description: Sets the reference value to the last stored value after a restart of the
system.
Note: The two parameters [RefMode] and [SafeRef] are conditionally
dependent on each other. If you require one of both functions, either
set [RefMode] to [Auto] or [SafeRef] to [Yes] .
Do not activate both functions simultaneously!
Tolerance range without influence on control [Deadband]
Description: Control is activated as soon as the deviation between reference
value and actual value increases the value of this parameter. A value
of 0.3 mm makes a dead band of ±0.3 mm without any reaction of
the control.
Range: 0.0 to 2.0 Default: 0.1
Increment 0.1 unit: [mm]