FMS BKS309.W.M, Руководство по эксплуатации

Страница: 17 / 48

Operating Manual BKS309.W.M
22.02.2019 17
Leave the menu for changing the traverse parameters. The LED above the
key is now off.
The LED is off as you leave the automatic mode.
Note
If the web is not moving the system may not be able to lead the web to the reference
value! The actuator possibly reaches its limit stops and may cause damage to the web.
Only switch to automatic mode when the web is moving slowly.
6.2 Manual mode
The following function are enabled in manual mode
Key Function
+
>3 Sec
Enter the menu for changing the system parameters. The LED is
on.
> 3 Sec
Enter the menu for changing the operating parameters. The LED is on.
Enter the menu for changing the traverse parameters. The LED is on.
The actuator approaches the stored center position.
Moving the actuator in 0.1 mm steps to the desired direction. Holding
the key will increase the speed of the movement.
Selection of the guiding logics. The system guides along the left edge
or line. The LED indicates "edgle left"
Selection of the guiding logics. The system guides along the right edge
or line. The LED indicates "edgle right"
+
By pressing both keys you will enable the center guiding mode. The
system will follow along the theoretical center line of the both sensor
positions.
The guiding logic is dependent on the applied number of sensors. You
can select the center guiding mode only if you have installed 2
sensors. One for each side of the web.
6.3 Changing and storing positions of the actuator
You can adjust the home, middle and maximum position of the actuator. These
values are stored as operating parameters [Home Pos], [CentrPos] and [Max Pos].
You can either changes these parameter directly via the operating parameter menu
or alternatively move the actuator to the desired position in manual mode and store
the approached position.