FMS BKS309.W.M, Руководство по эксплуатации

Страница: 21 / 48

Operating Manual BKS309.W.M
22.02.2019 21
Switch to manual mode. The LED is off
Enter the menu for changing the traverse parameters. The LED is on.
Scroll through the list of parameters to the menu point [SetZerPL] for
left sensor or [SetZerPR] for right sensor
After pressing briefly the LED starts flashing. The display indicates
"R
 Zr" or "R  Zr" in combination with the value for the current
position.
Enter the distance from the right sensor to the zero point or the left
sensor to the zero point respectively.
Confirming the selection will store the value.
Leave the menu for changing the traverse parameters. The LED above
the key is now off.
Home Position
This is the mechanical stop at the drive end of an individual traverse. This point is
approached during the reference run of the traverse to initialize the sensor position
after a first start-up. If you do not establish a zero point all displayed dimensions
refer to the home position of each traverse.
Position point
This is an individual point for each traverse that you can approach, adjust and store
in the controller. This point can be of help if you have to deal with frequent changes
web widths. After setting up the machine to a certain web width you can store the
current sensor positions. When you have re-adjusted the sensor positions for a
different web and like to change the original one, you can recall the stored position
in seconds.
7.5 Repositioning the traverses manually
You can position the sensors manually by moving the traverses. The sensors signals
are not monitored during the movement. This bears potential collisions with the
web.
As soon as the traverse reaches the mechanic stop the movement is stopped
automatically.
Key Function
Switch to manual mode. The LED is off
Enter the menu for changing the traverse parameters. The LED is on.
Re-positioning a single sensor – Reference to zero point
Scroll through the list of parameters to the menu point [Sens L] for left
sensor or [Sens R] for right sensor.
After pressing briefly the LED starts flashing. The display indicates
"PosR" or "PosL" in combination with the value for the current position
in reference to the zero point. If you have not set a zero point the
indicated value refers to the home position of the respective sensor.