FMS BKS309.W.M, Руководство по эксплуатации

Страница: 15 / 48

Operating Manual BKS309.W.M
22.02.2019 15
If you have installed an actuator of the FMS winderGLIDE series, you have to set the
below parameter as well:
WinderGLIDE – system parameter
Key Function
> 3 Sec
Enter the menu for changing the system parameters
Scroll through the list of parameters to the menu point [WinderGL]
Changing the parameter: the selected parameter name starts flashing.
This means that you can now change the value of the parameter.
Select the desired type
Confirm the changes: The selected parameter name stops flashing.
> 3 Sec
Leave the menu for changing the system parameters. The LED above the
key is now off.
Mounting side of the actuator – operating parameter
This value indicates the position of the actuator in regards of the rolling direction of
the web.
Key Function
> 3 Sec
Enter the menu for changing the operating parameters
Scroll through the list of parameters to the menu point [Actuator]
Changing the parameter: the selected parameter name starts flashing. This
means that you can now change the value of the parameter.
Select the mounting side of the actuator
Confirm the changes: The selected parameter name stops flashing.
> 3 Sec
Leave the menu for changing the operating parameters. The LED above the
key is now off.
Start the reference run of the traverse
To initialize the drives of the traverses the exact position of the sensors on the rail
hast to be set.
Key Function
With the controller being in manual mode, enter the menu for changing
the traverse parameters. The LED above the key will be on and the first
parameter is shown in the display.
Scroll through the list of parameters to the menu point [RefRun]
Confirming the selection will instantly start the reference run.
Leave the menu for changing the traverse parameters. The LED above
the key is now off.
The system is now configured and ready for operation.