Maintenance and Inspection Procedures Manual
Type:
CT
Series:
CTLS
LSA
Page: 2-3
AF 04800001
Revision No. 3
Date: 14 Sep 2008
Chapter
Procedure
Minimum Level of Certification
5 Engine
5.1
Engine Systems and Accessories
case dependent
5.2
Rotax 912 Engine
case dependent
5. 3
Carb Heat Control
¦
6 Fuel
System
6.4
Fuel System Inspection
±
6.5
Fuel Flow Check
¦
+
6.6
Intake Filter Inspection
¦
6.7
Fuel Filter Inspection
¦
6.8
Gascolator
Inspection
¦
7 Propeller
¦
8 Utility
Systems
8.3
Inspection of Cabin Heat System
±
9 Instruments
and
Avionics
9.3
Instrument
maintenance
¦
9.4
Inspection of Pitot and Static
System
±
10 Electrical
System
10.3.1
Inspection
±
10.4
Battery
Replacement
±
Where listed, “FD Training” indicates the requirement for Flight Design task specific training. Flight Design
task specific training may consist of one, or a combination of the following:
1. An approved Flight Design maintenance training course,
2. Individual training provided by a Flight Design representative
3. Training via multi-media or electronic means.
Note: For certificated persons such as an A&P, RLSA-M or persons working under the auspices of a
Repair Station, prior experience will be considered when determining the training required.
Important: Participation in training described in this manual shall not be construed as an implicit
authorization by Flight Design to perform inspections or repairs beyond the limitations set forth in the
applicable regulations of the governing aviation authority.