Fike CyberCat 50 10-070, Руководство по эксплуатации и техническому обслуживанию

Страница: 19 / 122

1.0 INTRODUCTION
UL S2203 CyberCat 50 Operation Manual 1-11
FM 3029134 P/N: 06-368-2 Rev 4, 08/2013
Exhibit 1-9: Programming Features Cont.
Circuit or
Component Program Feature or Option
Permitted
in UL
864?
(Y/N)
Possible Settings
(Defaults shown bold)
Settings
permitted
in UL 864 Notes
Defaults
(Photo/Duct
Sensor) Common
Loop Number of Device Y 1 1
Address of Device Y 1 – 50
Custom Message Y 60 character user defined
(1-001 DUCT DETECT
Loop 1 - Address 001)
Y Default / User Defined
Zone Assignments Y 1 – 254 2
Alarm Verification Y Time: 0 – 60 seconds
Y Enabled / Disabled
Sensitivity
Pre-Alarm 1 & 2 Levels Y
Enabled / Disabled
Y 0.6%/ft. – 4.0%/ft.
(0.1%/ft. increments)
3
Alarm Levels Y Acclimate: 0.8%/ft. – 3.4%/ft.
(High 2.0% - Low 2.5%)
4
Y Day/Night: 0.8%/ft. – 3.4%/ft.
(Day 1.5% - Night 3.4%)
Y Alarm / Supervisory /
Supervisory NL
Drift Compensation
(Warning/Trouble) Y 50 – 100%
Warning 80%/Trouble 100%
5
Walktest Y Walktest at Alarm Level /
Walktest with IR / Walktest at
1.3%
Device Summing
Broadcast Thresholds for
Summing (%OBS) N Enabled / Disabled
(8 levels 0.5%/ft. – 4.0%/ft. in
0.1%/ft. increments)
Summing Activation Level
(%OBS) N 1.0 – 10%/ft.
(0.5%/ft. increments)
Summing Broadcast State N Disabled / Alarm / Summing
Alarm / Supervisory Latching
/ Supervisory Non-Latching /
Pre-Alarm 1 / Pre-Alarm 2
Summing Addresses N 1 – 8 (Device addresses to
participate in summing group)
Remote Annunciator (See Exhibit 1-7 for programming features)
Notes:
1. CyberCat 50 has only one (1) addressable loop with a maximum of 50 devices.
2. Can be assigned to 4 discrete zones, 2 zone ranges or 1 range and 2 discrete zones.
3. Pre-Alarm 2 setting must always be set equal or higher than Pre-Alarm 1 setting.
4. High setting must be equal or lower obscuration setting than Low setting.
5. Can be set in 1% increments. Trouble must be higher % than Warning.