1.0 INTRODUCTION
1-30
CyberCat 50 Operation Manual
UL S2203
Rev 4, 08/2013
P/N: 06-368-2
FM 3029134
Exhibit 1-28: Programming Features Cont.
Circuit or
Component
Program Feature or Option
Permitted
in UL
864?
(Y/N)
Possible Settings
(Defaults shown bold)
Settings
permitted
in UL 864
Notes
Voice EVAC
Amplifier
Message Assignments – Single Channel
State
Y
Drill / Evac / Alert / Alarm /
Test Alarm / Supervisory /
Process
Message 1
Y
Message ID 1 – 16
1
Message 2
Y
Message ID 1 – 16
1
Silence
Y
Silenceable / Non-Silence
2
Speaker Circuit (1 - 4)
Y
Enable / Disable
3
Amplifier Zone Assignment
Y
1 - 254
4
Message Assignments – Dual Channel
State
Y
Drill / Evac / Test Alarm
Message 1
Y
Message ID 1 – 16
1
Message 2
Y
Message ID 1 – 16
1
Silence Y
Silenceable /
Non-Silence
2
Speaker Zones (1 - 4)
Y
1 - 254
5
Amplifier Designation
Y
Evacuation
/ Alert
6
Message Assignments – Page Only
State
Y
Drill / Test Alarm
Message 1
Y
Message ID 1 – 16
1
Message 2
Y
Message ID 1 – 16
1
Silence Y
Silenceable /
Non-Silence
2
Speaker Zones (1 - 4)
Y
1 - 254
5
Amplifier Synchronization
AMP Sync
Y
Enabled / Disabled
AMP Operation on Panel
Network
Y
Play Cfg Msg ID / Play Tones
/ Play New Msg ID
7
New Msg ID
Y
None / 1 - 16
7
Notes:
1.
Sets the first and second message that will be played in response to each panel state listed.
2.
The Page State cannot be silenced.
3.
Select the speaker circuits that will be active on the selected amplifier.
4.
Select the zone(s) that each amplifier will serve (1-254).
5.
Select the zone(s) that each speaker circuit will serve (1-254).
6.
Dual channel operation utilizes two amps interconnected together to form a single amp. One must be configured as the EVAC
amp and the other must be configured as the Alert amp.
7.
Configuration options become available if ‘Amp Sync’ is enabled. Allows playback of ‘tones’ or ‘new message’ while amps are
being synced. Prevents message cutoff during message sync.
