3. Installation
3-12
Festo P.BE-DLP-VSE-... en 0206a
Dismantling
1. Switch off the operating voltage.
2. Unscrew the two fastening screws of the switch module.
3. Lift up the switch module and remove it.
Fitting
1. Insert the switch module carefully in the groove.
2. Tighten both fastening screws alternately to the same
degree (tightening torque is 0.6 Nm ± 30%).
Please note
S
Do not tilt the switch module when inserting it. The fit-
ting position is clearly marked by a groove in the hous-
ing.
S
Make sure that the seal ring is seated correctly.
3.3.2 Setting the Local control unit
When the switch module has been dismantled, you will see
two DIL switches for setting the following parameters
(Fig. 3/18):
– the configuration of the Local control unit (with/without
measurement bus)
– the station number
– the diagnostic mode
Содержание DLP-VSE Series
