Festo DLP-VSE Series, Руководство пользователя

Страница: 57 / 112

4. Commissioning
4-3
Festo P.BE-DLP-VSE-... en 0206a
5. If the movement does not correspond to the labelling:
modify the tubing (see below).
6. Repeat steps 4 and 5 for the other position.
7. Position the limit switch (see below).
8. Local control unit with bus module: commission the Local
control unit in accordance with chapter 4.2 or 4.3 .
9. Use the key-operated switch to select the desired operat-
ing mode.
10. Remove the key from the switch and keep it in a safe
place.
Please note
Remove the key from the switch when the Local control
unit is operating. The lock barrel will then be better pro-
tected against environmental influences.
Modifying the tubing
If the movement of the fittings does not correspond to the
labelling on the knob-operated switch, modify the tubing as
follows:
1. Turn the key-operated switch to 0.
2. Only with DLP-VSE-3-...: turn the knob-operated switch to
HALT/STOP.
3. Switch off the compressed air.
4. Swap the tubing.
5. Repeat the steps in section 4.1.2.