6
www.euroklimat.it
1.0 GENERAL INFORMATION AND SAFETY
The contents of this manual must be read and fully understood before managing the units. This usage and maintenance manual
illustrates the operation and rules of usage and ma
intenance of the machines according to the Manufacturer’s criteria.
The Manufacturer of the equipment declines all responsibility for injury or damage resulting from failure to comply with the regulations
reported herein.
In the event of clarifications, further information or doubts of any kind, the Manufacturer is available to provide all of the relevant
instructions through his qualified technical personnel.
In order to facilitate identification and recognition of the machine, always refer to the technical data reported on the plate outside the
units and, in particular, the series number.
The machine must not be used under conditions other than those for which it was designed, not even for limited periods of time. The
incorporation of parts, which do not guarantee safety, is strictly forbidden.
The refrigerant fluid contained in the unit is R410A. The type of refrigerant used is reported on the technical plate on the machine. The
refrigerant safety data sheet can be found at the back of this manual.
The lubricating oil in the compressor is not dangerous; nonetheless, it must only be handled wearing gloves and it must not be
swallowed. The lubricating oil safety data sheet can be found at the back of this manual.
The procedures set out in the following chapters of this manual must be complied with for all work relating to installation, start-up, use,
modifications of conditions of use and operating modes, routine maintenance, inspections and periodic maintenance. This manual must
always be kept at hand for consultation.
This machine must only be used under the conditions foreseen by this usage and maintenance manual. Below
we wish to draw USERS’
attention to various recommendations to avoid abnormal conditions of use; nonetheless, all other conditions of use not expressly
foreseen by this manual must be avoided.
Do not climb onto the machine. Do not operate the machine unless it has been installed correctly in the prescribed position. Do not start
the machine without closing the doors of the electrical panel properly.
Avoid getting close to the feed-in and air expulsion points. Do not clean the machine when it is in operation. Do not install the machine
in corrosive and/or explosive environments.
Do not disconnect or remove safety components. The machine must not be used under conditions other than those stated in this
manual.
The Manufacturer declines all responsibility for damage caused directly or indirectly to persons or property as a result of failure
to comply with these instructions.
