16
www.euroklimat.it
Assembling the mounts is extremely simple as fixing holes are already provided in the base of the refrigeration unit
and the “
nut/locknut
”
system
on the main pivot of the support makes their installation quick and simple. After positioning the supports and placing the chiller, it is possible to
adjust the height using the adjusting nut, making sure that the machine is perfectly level. A drawing is included with the documents supplied
with the chiller, indicating the correct assembly procedure for this accessory, which takes into account the distribution of the weights inside the
machine. The supplied mounts may differ to adapt to the real distribution needs of the loads of the chiller; in this case, it is necessary to pay
attention to the indications in the diagram and follow the instructions carefully.
The installation procedure for the anti-vibration mounts is illustrated in the following paragraph.
▪
INSTALLATION OF THE ANTI-VIBRATION SPRING
JACKS COMPONENTS (fig.1)
E1
M16x100mm grain with lodging for 8 mm allen key
E2 - E6
Low nut M16 - UNI 5589
E3
Broken elastic washer UNI 1751
E4
Steel-Disc Ø 80x5 for M16 jack
E5
High nut M16 - UNI 5587
Configuration of the jack before the insertion inside the anti-vibration mount:
8 mm allen key Simple key of the 24
TH
PROCEDURE TO INSERT THE JACK INSIDE THE ANTI-VIBRATION MOUNT.
fig.2
Insert the M16x100 mm threaded stud
(E1)
in the threaded hole in the mount upper plate and using an 8mm allen key fit it in for 15-
20 mm
(A1)
.
fig.3
Using the simple key of the 24
TH
, fit the M16 grain
(E1)
mounted on the anti-vibration mount in the hole of the machines base, with
steel nut
(E6)
. In this way, the anti-vibration mount is ready to be installed as shown in the next page.
BE CAREFUL:
The antivibration mount must be placed under the machine according to the image presented in the “
foot print
” scheme in the
following pages.
