Epson C8 Series, Руководство манипулятора

Страница: 43 / 346

Setup & Operation 3. Environment and Installation
C8 Rev.13 29
3. Environment and Installation
Installation and transportation of robots and robotic equipment shall be performed
by qualified personnel and should conform to all national and local codes.
3.1 Environmental Conditions
A suitable environment is essential for the robot system to function properly and safely. Be
sure to install the robot system in an environment that meets the following conditions:
Item Conditions
Ambient temperature
*1
5 to 40
°
C
Ambient relative humidity 10 to 80 % (no condensation)
First transient burst noise 1 kV or less (Signal wire)
Electrostatic noise 4 kV or less
Environment - Install indoors.
- Keep away from direct sunlight.
- Keep away from dust, oily smoke, salinity, metal
powder or other contaminants.
- Keep away from flammable or corrosive solvents
and gases.
- Keep away from water.
- Keep away from shock or vibration.
- Keep away from sources of electric noise.
*1 The ambient temperature conditions are for the Manipulators only. For the Controller
which the Manipulator is connected to, refer to the Robot Controller manual.
When using the Manipulators in inadequate environments that do not meet the above
conditions, please contact the distributor.
For the Protection-model Manipulator, be sure to install the robot system in an environment
that also meets the following conditions:
Item Conditions
Environment - Install indoors.
- Keep away from direct sunlight.
- Keep away from salinity or other contaminants.
- Keep away from flammable or corrosive solvents
(including water) and gases.
- Keep away from organic solvents, acids, alkalis, and
chlorine cutting fluids.
- Do not use in water.
- Keep away from shock or vibration.
- Keep away from sources of electric noise.
- Available under the environment with dust, oily smoke,
and metal *
2
.
*1 The Manipulator body is mainly made of iron and aluminum. It is not rust-proofed.

NOTE