Epilog FusionPro 32, Оригинальное руководство пользователя

Страница: 9 / 148

Safety Features and Regulatory Compliance
Epilog has incorporated specific safety features into the Model 16000 Laser System in order to meet the
requirements of 21 CFR 1040 and the International Standard IEC 60825-1. These safety features include:
• A safety enclosure (cabinet), which fully encloses the engraving laser and its beam path.
• Dual redundant interlock systems that turn off the engraving laser when the window is opened.
• A visible emission indication when the Laser Diode Pointer (Red Dot Pointer) is operating. There is an
LED indicator on the machine’s front panel.
21 CFR 1040 and IEC 60825-1 require that certification, identification, and warning labels be placed on laser
products. Reproductions of labels on the Epilog Model 16000 Laser System follow, with their locations
specified:
1. Certification/Identification Plate: This engraved plate is located on the right side of the machine’s
cabinet.
2. Warning Logotype: This label is located on the right side of the machine’s cabinet, above the
Certification/Identification plate.
3
3. Descriptive Label: This label identifies the classification of the
Model 16000 in accordance with 21 CFR 1040.10 and IEC 60825-1. It is
located on the right side of the machine’s cabinet, below the Warning
Logotype.
4. Non-interlocked Protective Housing Safety Labels: These labels
are located on, or adjacent to, removable access covers on the
machine’s cabinet as shown in the diagrams to follow. Where a label
is located on a removable cover, there is an additional label under
the cover so that it will be visible when the cover has been removed.
5.
Defeatably-interlocked Protective
Housing Safety Labels:
There is one
label on each of the machine’s cabinet
doors; one on the front door and one
on the top door.
6. Emergency Stop Label: This label is
located below the red Emergency Stop
switch on the top right side of the
machine.
7. Electrical Safety Label: This label is
located on the back of the machine in
the lower left hand corner.
8. Main Breaker Label: This label is
located on or above the power module
panel at the right side of the machine’s
cabinet.
9.
Aperture Safety Label:
This label is
located above the aperture, inside the
cabinet, where laser beams enter the
machine’s engraving area.
10. Power Labels: The appropriate label
for the machine is located on or below
the power module panel at the right
side of the machine’s cabinet.
11. Fire Warning Label: There are two
labels on top of the machine’s cabinet;
one to the left and one to the right of
the top cabinet door.
11
4
5
6
7
8
9
10
- 5 -
SECTION 1: SAFETY