Epilog FusionPro 32, Оригинальное руководство пользователя

Страница: 80 / 148

Jog Menu
Access the Jog Menu by pressing the Jog key, which will turn green
when active. The Jog Menu allows you to adjust the current X and Y axis
positions of the laser head. You may change the current position of the
laser head either using the Joystick, or by entering precise coordinates.
The Nudge arrows allow you to fine-tune the position down to a
thousandth of an inch. Once you are finished using the Jog Menu, press
the Jog key again to return to the main Job Menu. Press the Reset key to
return the laser back to its home position.
Auto Focus
When you have jogged the lens carriage above your material, press
the Auto Focus button to use the pluger Auto Focus. The table will rise
until the material touches the plunger, then set the table to the correct
height. Your job should now be in focus.
Focus Menu
To access the Focus Menu press the Focus key, which turns green when
active. The Focus Menu is used for raising or lowering the table level to
focus the laser precisely to your engraving or cutting material using the
Focus Gauge. The height of the table is adjustable by either using the
joystick, or using the Nudge arrows to fine-tune the height down to a
thousandth of an inch. Once you are finished using the Focus Menu,
press the Focus key again to return to the main Job menu.
Home Table
Pressing the Home Table button resets the table height to its home
position, which is the default every time you turn on the machine.
Jogging
Jog Axis
(inches)
Current Position
Nudge Amount: 0.005
Auto Focus
Done
Move To
X: Y:
Move
0.0 0.0
X:1.000 Y:1.000 < >
< >
Idle
Focus Menu
(inches)
Current Focus
0.000
Home Table
Done
Nudge Table: Move Table
Focus
0.0
0.005
< >
- 76 -
SECTION 6: CONTROL PANEL