Endress+Hauser Liquiline System CA80HA, Руководство по эксплуатации

Страница: 184 / 214

Maintenance Liquiline System CA80HA
184 Hauser
3. Select Draw up dispenser .
4. Open the dispenser holder by pressing both snap-fit hooks together and removing it.
5. Turn the dispenser counterclockwise to remove it from the Liquid Manager.
6. Remove the adapter and the dispenser from the dispenser drive. To do so, hold the
dispenser by the black block at the lower end and pull the block from the metal pin.
Inserting new dispensers
1. Screw a new dispenser onto the Liquid Manager. Make sure that the dispenser is
connected correctly.
2. Slide the dispenser holder over the snap-fit hooks. Ensure that the holder snaps into
place. Make sure that the drain hose D6 is routed behind dispenser 7.
3. Secure the cover and place the bottle tray back into the housing.
4. Connect the reagent hoses to the corresponding connections on the Liquid Manager.
5. Select
Menu / Operation / Dispenser replacement / Dispenser selection .
6. Select the dispensers that you have replaced and press OK to confirm.
7. Select Reset operating time counter .
8. Select Menu / Operation / Maintenance / Bottle change mode / Bottle insertion / Bottle
selection .
9. Select all the bottles and press OK to confirm.
10. Select Confirm bottles inserted .
11. The system must be calibrated after a replacement routine. Select Menu / Operation /
Manual operation / Determine calibration factor .
12. After the calibration go back to MODE / Continue automatic mode or MODE / Start
automatic mode .
12.2.9 Replacing the Liquid Manager
You require the following parts:
CAV800-xx+ for CA80HA
Preparations to replace the Liquid Manager
1. Rinse the system (see the "Rinsing the system" section).
2. Remove the bottles and the bottle tray.
3. Remove the cover of the carrier board.
Removing the dispensers
1. Menu / Operation / Dispenser replacement / Dispenser selection Select .
2. Select all the dispensers.
3.
Draw up dispenser Select .
4. Disconnect the power to the analyzer.