Eelectron BO08A01KNX, Руководство по продукту

Страница: 42 / 51

BO08A01KNXFI01010002.DOC
Din Rail 8 Output Module– Product Handbook
42/51
Eelectron SpA, Via Magenta 77/22, I-20017 Rho (MI), Italia
+39 02.9316681 +39 02.93507688
info@eelectron.com www.eelectron.com
BO08A01KNXFI01010002.DOC
C.F. e P.IVA 11666760159
Capitale sociale: 800.000,00€ interamente versato
Tribunale di Milano 359157-8760-07
CCIAA Milano 148549
8.3. Louvres automatic movement
If the channel is configured for Venetian control (Parameter “
Shutter Type
= Venetian”) it is
possible to enable an automatic movement of the louvres which is executed at the end of
movements of the shutter.; these movements are:

Movement for scene command (if brings the shutter in a position different from totally up)

Movement at the end of a lock or alarm state (if brings the shutter in a position different
from totally up)

Movement for a Position % command (if brings the shutter in a position different from
totally up )
This automatic function moves the louvres up after a shutter down movement and down after a
shutter up movement.
KNX PARAMETER
SETTINGS
Louvres automatic movement

Never

After up movements

Always

After down movements
Set when the automatic movement must start.
Number of automatic steps after move up
1 ÷ 15
Number of automatic steps after move down
1 ÷ 15
This parameter set the time of the movement : if this parameter is set to “2” and
“Step time for
louvres movement (x 100ms)”
is set to “3” then the automatic movement is 300ms x 2 = 600ms
Pause time between 2 step move ( x100ms)
3 ÷ 10
Set the minimum time delay between 2 step movements.
8.4. Additional Functions
In BO08A01KNX for channels configured for shutters 3 additional functions can be enabled:

SCENE FUNCTION
: The scene function manage two possible commands to the device:
perform scene
, that is a command to create a specific condition;
learn scene
, that is a
command to memorize the current status (at the moment the command is received) of the
shutter position, and then reproduce it once the perform command is received.

LOCK FUNCTION
: this function according to the command received from the bus, blocks
the shutter in a specific condition when a “lock on” command arrives, this state is kept until
a “lock off” command is received; any command received during the period in which the
block is activated is not executed.

ALARM FUNCTION
: this function allows linking the shutter channel to a rain or wind
sensor to protect it from damage.
[!]
This function (if enabled) requires the sensor linked to
send cyclically a telegram, even if The alarm is off. If the shutter does not receive any
telegram for a defined time (see parameter “
supervision time for alarm
”) it goes in the
alarm position as if it would have been received a alarm telegram.