EDM Solution 862, Руководство по установке

Страница: 41 / 262

Programming 41
Disable Factory Default
LOCATION 900
0
This feature prevents the control panel from being manually defaulted via the default button or
to prevent using a programming key to perform an automatic download to the control panel
when the system is disarmed.
A zero programmed into this location will allow defaulting of the control panel. If 15 has been
programmed into this location, defaulting of the control panel will not be permitted and the
Installer Code MUST be used for further programming of the control panel.
If the Installer Code is not known, the control panel will need to be returned to your EDM
Distributor for exchange. A nominal fee applies for this service.
Electronics Design and Manufacturing Pty Limited does not recommend the use of this
feature.
If the option is required to disable the option of being able to default the control panel, a
special procedure has been implemented to eliminate the possibility of accidentally setting this
option. The default button on the PCB must be held down while programming this location.
How To Prevent Manual Defaulting Of The Control Panel
1. Enter Installer’s Programming Mode (i.e.
1234
followed by the
#
button).
Two beeps will be heard and the data currently programmed in “LOCATION 000” will
be displayed via the hand held programmer or remote codepad.
If you are using a remote codepad, the STAY and AWAY indicators will begin to flash to
indicate that Installer’s Programming Mode has been accessed.
2.
From the hand held programmer or remote codepad, go to "LOCATION 900".
(e.g..
900
followed by the
#
button).
3. Hold down and continue to hold down the DEFAULT button.
The default button will be located at the top of the PCB next to the PROGRAMMING
KEY connecting socket.
4. Program a 15 into "LOCATION 900".
(e.g..
15
followed by the
*
button).
5. Release the default button.
6. Enter command
960
followed by the
#
button to exit Installer's Programming
Mode. Two beeps will be heard and the system will return to the disarmed state.
If you are using a remote codepad, the
STAY
and
AWAY
indicators will extinguish to
indicate that the system has returned to the disarmed state.
Electronics Design and Manufacturing Pty Limited ISSUE130