ECOSAIRE EN Series, Руководство пользователя

Страница: 118 / 142

OEM
CAREL code +030221791 - rel. 2.1 – 21/09/07 10
2.6 Installation of the steam hose and condensate return hose
ƒ The connection between humidifier and distributor must be made using a pipe
suitable for this purpose, such as the CAREL hose.
ƒ Avoid the formation of pockets or traps where the condensate may
accumulate.
ƒ Make sure that the hose is not choked due to tight curves or twisting.
ƒ Fasten the ends of the hose with screw clamps.
The pipe may run according to either of the two following solutions:
IMPORTANT WARNING:
the length of the steam pipe should not exceed 4 m.
To allow the drain trap in the steam condensate hose to operate properly, it must be filled with water before starting the
humidifier.
2.7 Characteristics of the water
2.7.1 Supply water
The humidifier must be supplied with mains water, wit the following characteristics:
ƒ pressure between 0.1 and 0.8 MPa (1 to 8 bar, 14.5 to 116 psi);
ƒ temperature between 1 and 40 °C;
ƒ instant flow rate not lower than the rated fill solenoid valve flow rate (refer to table 2.4.1);
ƒ connection type ¾”G male.
Steam hose
Condensate hose