ECKELMANN Virtus 5 Series, Руководство по эксплуатации

Страница: 128 / 183

Firmware V7.16.x 16.05.2023 128/183
The screen contains the following parameters:
Special inputs Eingabe Vorgabe
Message text Shunt lock (predefined designation of the
special input) - Shunt lock
PriorityXX Priority of the signal / alarm input --, 0..99 0
Delay [sec.] XX Delay time of the signal / alarm in seconds 0..255 1
Quiescent current (low-active) X Alarm is signalled if
- quiescent current = Yes: (signal voltage not
present, low-active)
- quiescent current = No: (signal voltage is
present, high-active)
Y/N N
Signal input
Module
Module
1)
to which the message / alarm signal
is connected
SIOX1 ..SIOX4 -
Submodule XX
Submodule
1)
to which the message / alarm
signal is applied; this is ONLY visible if
module=DDC1..DDC4 has been selected
1..4 -
Input XX
Input
1)
to which the message / alarm signal is
applied
1..12 -
Status XX Current status of the input:
OK = light grey, no signalling
Waiting = yellow: signalling, delay time running,
Message = green: no alarm
Alarm = red: signalling, alarm / message has
been tripped - -
1)
Designations of the supported modules / inputs:
CI 4x00 system centre, internal inputs IN1 / IN2 (terminals A1, A2 / B1, B2)
SIOX1 1. extension module, inputs 1 .. 12
SIOX2 2. extension module, inputs 1 .. 12
SIOX3 3. extension module, inputs 1 .. 12
SIOX4 4. extension module, inputs 1 .. 12
DDC1 1. GLT DDC module 1
DDC2 2. GLT DDC module 2
DDC3 3. GLT DDC module 3
DDC4 4. GLT DDC module 4
Note: GLT = building control and. DDC = Digital Direct Control
Only those SIOX modules and GLT PLC modules are provided for selection that have been configured
accordingly in screen 4-1-1! A description of the functions can be found in chapter
Digitaleingänge .
