ECI XDM-300, Руководство по установке и обслуживанию

Страница: 134 / 266

Equipment Installation XDM-300 Installation and
Maintenance Manual
3-76 ECI Telecom Ltd. Proprietary 417006-2311-0H3-A00
To install a triple-slot TPM in the TPU:
1. Check that the module has not been physically damaged during shipment,
and that the antistatic protection bag of the original packaging is sealed.
2. Remove the module from its antistatic protection packaging and perform a
visual inspection to detect damage during shipping. Report any problems.
3. Record the hardware and software versions indicated on the module’s
identification labels.
4. Identify the assigned slot, and insert the rear end of the module into the
corresponding module guides.
5. Push the module in until it mates the chassis connectors and the front of the
module is flush with the front of the XDM-100 shelf. Make sure the two
fastening screws are free to move backward as the module slides in. If you
feel resistance before the connectors are mated, pull the module out and
repeat the procedure.
6. Fasten the module to the chassis by tightening the two fastening screws.
7. After inserting the modules, check for correct installation against the
module insertion diagram. Install blank panels over any free slots.