ECI XDM-300, Руководство по установке и обслуживанию

Страница: 122 / 266

Equipment Installation XDM-300 Installation and
Maintenance Manual
3-64 ECI Telecom Ltd. Proprietary 417006-2311-0H3-A00
To install the SIM16_1 mechanical adapter:
1. Check that the adapter has not been physically damaged during shipment,
and that the packaging bag of the original packaging is sealed.
2. Remove the adapter from its protection packaging and perform a visual
inspection to detect damage during shipping. Report any problems.
3. Insert the rear end of the adapter into the card guides.
4. Push the adapter in until the front of it is flush with the front of the
XDM-300 shelf. If you feel resistance before the adapter is in place, pull it
out and repeat the procedure.
5. Secure the adapter in place by tightening the two captive screws.
To install a SIM16_1 module in a quad slot:
1. Check that the SIM16_1 mechanical adapter is properly installed in the
corresponding quad slot.
2. Check that the SIM16_1 module has not been physically damaged during
shipment, and that the antistatic protection bag of the original packaging is
sealed.
3. Remove the module from its antistatic protection packaging and perform a
visual inspection to detect damage during shipping. Report any problems.
4. Record the hardware and software versions indicated on the module’s
identification labels.
5. Insert the rear end of the SIM16_1 into the module guides in the
mechanical adapter.
6. Push the module into the guides of the appropriate slot. Push slowly
backwards to mate the connectors until the front of the module is flush with
the front of the adapter. Make sure the two fastening screws are free to
move backward as the module slides in. If you feel resistance before the
connectors are fully mated, retract the module and repeat the procedure.
C
AUTION
:
When inserting a module, make sure to carefully
align it with the adapter guide rails. If you feel resistance
during insertion, immediately retract the module and repeat
the process.
Hold the module straight during insertion and removal. Pull
or push it slowly and carefully until it is in the correct
position.