ECI XDM-300, Руководство по установке и обслуживанию

Страница: 120 / 266

Equipment Installation XDM-300 Installation and
Maintenance Manual
3-62 ECI Telecom Ltd. Proprietary 417006-2311-0H3-A00
Figure 3-42: Inserting an I/O module in the I/O slots
To install an I/O electrical, optical, or CWDM module in the
module cages:
1. Check that the module has not been physically damaged during shipment,
and that the antistatic protection bag of the original packaging is sealed.
2. Remove the module from its antistatic protection packaging and perform a
visual inspection to detect damage during shipping. Report any problems.
3. Record the hardware and software versions indicated on the module’s
identification labels.
4. Identify the assigned slot, and insert the rear end of the module into the
corresponding module guides.
5. Push the module into the guides of the appropriate slot. Push slowly
backwards to mate the connectors until the front of the module is flush with
the front of the XDM-300 shelf. Make sure the two fastening screws are
free to move backward as the module slides in. If you feel resistance before
the connectors are fully mated, retract the module and repeat the procedure.