38
Chapter 2 Basic Operation
Copyright © 2019 Duplo Corporation All Rights Reserved
6
Set the separating pressure adjustment
dial to [0].
• Paper separating pressure increases as the
scale value increases, and paper separating
pressure decreases as the scale value
decreases.
• When double-feed occurs, increase the
separating pressure by 0.5 on the scale.
7
Touch the
or
key to set the
processing speed.
• If paper is folded abnormally, and
conveyance motor error occurs when
processing thick paper, set the processing
speed referring to “Thick paper mode”.
Chapter 3 “8-1. Thick paper mode” (p.61)
• When paper jam or abnormal folding
occurs by using thin and flimsy paper,
adjust the processing speed referring to
“Thin paper mode”.
Chapter 3 “8-2. Thin paper mode” (p.61)
• The processing speed can be changed during folding process or in the idling state. However,
folding misalignment may be caused by changing the processing speed largely.
[A]
[B]
8
Adjust the position of the paper
receiving tray.
Set to [A] to stack ejected paper diagonally.
Set to [B] to stack ejected paper straight.
Refer to Chapter 3 “7.
In the following cases, proceed to step 10.
• Set [Folding Mode] to single fold.
• Set the paper receiving tray to [B].
The paper support guide cannot be used when the paper receiving tray is set to [B].
• Although the paper receiving tray is set to [A], the paper support guide is not used.
[a]
[b]
[A]
[a]
[A]
9
Attach the paper support guide [A] to
the paper receiving tray from the paper
ejecting section.
• M
atch the concave sections
[b] (two points)
on the reverse side of the paper support
guide [A]
with the convex section
[c]
on the
paper receiving tray to attach the paper
support guide.
