DRESSTA 515C, Руководство оператора

Страница: 144 / 205

MAINTENANCE
SECTION 5
Page 37
DRESSTA OM515C520C99/1E
ENGINE
Fig. 5.27. Engine Valves
1. Suction Valves 2. Exhaust Valves
6. Install the valve covers and torque to 24 [Nm].
NOTE: Refer to ENGINE OPERATION AND MAINTENANCE MANUAL for more detailed
instructions of valve lash adjustment.
5.12. ETHER INJECTOR
PRECAUTIONS
WARNING! Ether starting fluid is highly flammable. Follow strictly the
precautions on the container. An explosion can result if sparks or flame contact
the ether or if the container is stored where the temperature exceeds 70 [°C].
1. Do not use the ether injector when the air temperature is above freezing (0 [°C]).
2. Do not smoke when using ether starting fluid.
3. Do not store fluid containers in the operator's compartment.
4. Keep the fluid containers out of reach of children.
5. Do not breathe the hazardous ether vapor.
6. Do not let ether contact you skin, because it can cause frostbite.
7. Never puncture the fluid container or put it into a fire. Dispose of empty containers properly.
8. For your safety, remove the ether container when welding, grinding, or using a torch on the
machine.
NOTE: Improper starting fluids can cause valve seizure and severe damage to the engine. Consult
an authorized distributor for the recommended starting fluid to be used.
IMPORTANT: The ether starting valve inlet must be sealed against the entry of dirt at all times by
having a container installed or by installing the dust cap provided with the valve.
INSPECTION AND CLEANING
Make certain that ether is available under pressure. To do so, remove the ether container and check
if a good spray is obtained. If not, replace with a new container. If a good spray was obtained. Install
the container and test the ether injector as follows: