10
0
PAUSE
UNLOCK
DOOR
ADVAN
ENTER
DEL
RESET
STOP
START
SIGNAL 1
The numeric key can be used for all selections.
If pressed during the execution of a programme, it disables all the relays outputs,
except the draining relay.
It is disabled during distribution and spin cycles.
It controls the door electromagnet.
It is only enabled if the programme is not being executed.
During spin execution, with the spin engine at high or low speed, it overrides the
cycle automatically making a pause during the slowing down of the engines.
During the execution of the programme the current step ends and the following one
starts.
During the selection of a programme, before pressing START, it allows to start the
programme not from the beginning but from a cycle further forward the programme
to be started.
During the cycles edition it allows to skip to the following step.
To confirm selections or adjustments either during edition or execution. During
execution it displays the programme number or the current step.
To override any selection or input
It finishes the current activity (execution or programming). With the machine
connected but not in execution, when pressed together with RESET, it displays the
version of the installed software.
It starts the execution of the selected programme.
It reinitialise a programme after a pause.
When pressed together with the key RESET, it enables the introduction of an access
code
Temperature fault
It indicates the lack of temperature, normally due to malfunctioning of the sensor,
heater or defective circuit.
The test is always activated.
If the fault occurs during a heating step, the step is cancelled, and the buzzer is
activated for 2 sec., the message "TEMP. FAULT" is displayed and the LED lights
on. The programme is still working, skipping only heating steps. It is a temperature
fault, below 2 ºC and above 93 ºC. The LED lights off when the programme starts.
